This is probably one of the most versatile items we sell. These make great components for building engine mounts, transmission mounts, crossmembers, skid plates, Trac-bars, etc. Essentially anything you need to hard mount, but also have the option of removing at a later date. The outer sleeves are 1.75" OD X .120 wall DOM steel, the inner sleeve is .75" OD X .120 wall DOM, and the joint is designed for a 1/2" bolt. We then de-bur all steel by hand in our shop, and include 2-Daystar polyurethane bushings. All of the components from this kit are manufactured right here in America.
We use these joints on a daily basis for our Engine mounts and Trac-bar kits. These kits have been used with our other products for quite some time, and we have had zero failures to date. Same quality as other places, but at a fraction of the price.
- (2) High quality polyurethane bushings
- 1.75" X .120" wall outer sleeve
- .75" X .120" wall inner sleeve
- 3" wide, OD.
- De-bur'd before shipping
Note: Inner sleeve lengths may vary slightly. Trim excess as deemed necessary. This will not effect the function of the joint.